SKID
Offshore single piece skid design. Skid has a surrounding cage and environmental drip pan to hold fluids in the event of leakage.

ENGINE
• CAT, Cummins, John Deere, or engine of your choice
• Flywheel adaptation for a hydraulic gear box
• Mounted on a steel channel skid

CENTRIFUGALS
The fluid handling system includes three centrifugals one (1) Mission Magnum 3 x 4 to provide mix water, one (1) 4 x 5 Mission Magnum recirculation centrifugal pump, and one (1) 4 x 5 Mission Magnum for pressurizing the down hole pumps.

STAINLESS STEEL CIRCULATING CEMENT MIXING TUB WITH AUTOMATIC DENSITY CONTROL SYSTEM

• The system is designed for the following operating performance:
  • Density Ranges: 6 to 22 lbs/gal
  • Mixing Rates: 0 to 14 bpm
• Details of the CCM are as follows:
  • Mix water is supplied to the mixing chamber from a hydraulically driven mix water centrifugal pump.
  • The CCM system uses a control valve educator system with an inlet where by cement is blown into the unit via a 5” piping to produce highly consistent cement slurries. The mixing chamber has the ability to re-circulate slurry during periods of low mix rate operation or as a method of adjusting mixing energy and maintaining uniform slurry.
  • The cement slurry exits the Cement Mixing Chamber directly into CCM mixing tub.
  • Rubber 90 and an aluminum pipe will be furnished to take dust away from the unit and down to the ground.
  • One (1) 6 BBL capacity mixing tub with two compartments or larger if needed
  • 5 H.P. hydraulic agitators with shaft and paddle in each compartment.
  • Micro Motion F Series 3” Densitometer – Non Radioactive will be installed in the recirculation line.
  • A 2” wash down hose port will be installed that will TEE from the mix water line with a ball valve.